Westinghouse PT10475, Инструкция по эксплуатации, Страница: 10 / 14

When circle cutting, adjust rip fence so that distance
from blade to hole in fence arm is at the desired radius
and tighten screws. Place saw so that the hole in fence
arm is over centre of circle to be cut (drill hole for
blade or cut inward from edge of material to get blade
into position). When saw is properly positioned, drive a
small nail through hole in fence arm. Using rip fence as
a pivot arm, begin cutting circle. For circle cutting, the
cross bar should be up, as shown in figure J.
MAKING A POCKET CUT (FIGURE K), IT IS NOT
NECESSARY TO DRILL A PILOT HOLE:
•
Mark the desired starting point
• Tilt the tool forward and place the rounded
front edge of the saw shoe on the workpiece
so the blade does not touch the surface
• Switch the tool on and slowly feed the saw
blade into the workpiece at the desired
starting point.
3 1 7
10 6
SIMBOLOS
• La etiqueta en su herramienta puede incluir los siguientes símbolos. Los
símbolos y sus definiciones son como sigue:
V ---------volteos A--------amperios
Hz--------hertzios W-------vatios
Min-------minutos ----corriente alternativa
---corriente directa ----no hay espacio para carga
------Construcción Clase I (conexión a tierra ----terminal de conexión a tierra
-----Construcción clase II ----revoluciones o
reciprocidad por minuto
---Lea el manual de instrucciones ----Uso apropiado de
protección de respiración antes
de utilizar
------Uso apropiado de
protección visual -----Uso apropiado de
protección visual
sfmp-----pies de superficie por minuto
Descripción Funcional
1. Gatillo del interruptor
2. Botón de bloqueo
3. Palanca de seguro de cuchilla de sierra
4. Cuchilla de sierra
5. Rodamiento de guía de cuchilla
6. Base
7. Control de velocidad
8. Palanca de acción de corte
9. Adaptador de aspiradora
10. Llave hexagonal
OPERATING INSTRUCTIONS
Problem Possible Cause Possible Solution
• Unit will not start • Cord not plugged in • Plug tool into
a working outlet
• Circuit fuse is blown • Replace circuit fuse
(If the product
repeatedly causes the
circuit fuse to blow,
discontinue use
immediately and have
it serviced at center or
authorized servicer).
• Circuit breaker is • Reset circuit breaker.
tripped (If the product
repeatedly causes the
circuit breaker to trip,
discontinue use
immediately and have
it serviced at a
service center or
authorized servicer).
• Cord or switch is • Have cord or switch
damaged replaced at a Service
Center or Authorized
Servicer
ADVERTENCIAS DE SEGURIDAD DE LA SIERRA
TROUBLESHOOTING