4 of 9
ISSUED: 05-21-04 SHEET #: 201-9226-1
Visit the Westinghouse Web Site at www.westinghousedigital.com
For customer service call
1-866-287-5555
.
concrete
surface
1
3
2
N
Drill holes and insert anchors (
N
)
Place plate
over anchors (
N
) and secure with screws (
J
)
Tighten all fasteners (
J
)
N
For Concrete Surfaces
use wall bracket (
A
), making sure
that it is level, as a template to mark holes. Drill 1/4" (6
mm) dia. holes to a minimum depth of 2.5" (64 mm). Insert
anchors (
N
) in holes flush with wall as shown (right). Place
wall bracket (
A
) over anchors (
N
) and secure with #14 x
2.5" (6 mm x 65 mm) wood screws (
J
) and screw head
covers (
K
). Tighten screws (
J
) with phillips screwdriver (not
provided) and push screw head covers (
K
) over wood screw
heads (
J
).
A
J
WARNING
• When installing wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual concrete surface in
the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the
block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifications. It is
suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid
breaking out the back of the hole when entering a void or cavity.
• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
• Make sure that the wall will safely support four times the combined load of the equipment and all attached hardware
and components.
K
J
A
• Tighten concrete anchor bolts firmly, but do not
overtighten. Overtightening can damage the bolts,
greatly reducing their holding power.
• Never tighten in excess of 80 in • lb (9 N.M.).
WARNING
CUT
A
W
A
Y
VIEW
INCORRECT
concrete
plaster/
dry wall
mounting
plate
CORRECT
concrete
plaster/
dry wall
mounting
plate
• Concrete anchors are
not
intended for attachment to
concrete wall covered with a layer of plaster, drywall,
or other finishing material. If mounting to concrete wall
covered with plaster/drywall is unavoidable, plaster/
drywall (up to 5/8" thick) must be counterbored as
shown below. If plaster/drywall is thicker than 5/8",
custom fasteners must be supplied by installer.
WARNING