ISSUED: 04-16-04 SHEET #: 095-9194-1
3
of
6
Visit the Westinghouse Web Site at www.westinghousedigital.com
For customer service call
1-866-287-5555
.
For Concrete Walls
drill one 1/4" (6 mm) dia. hole to a
minimum depth of 2" (51 mm). Insert anchor (
E
) in hole
flush with wall as shown (right). Place wall bracket, with
slot on tube facing down, over anchor (
E
) and secure
with #14 x 2" wood screw (
D
). Make sure wall bracket is
level, mark other hole and repeat steps with other
fasteners. Tighten all fasteners.
IMPORTANT:
Make sure wall bracket is level on wall.
concrete
wall
1
3
2
E
E
wall bracket
D
E
WALL
BRACKET
CUT
A
W
A
Y
VIEW
WARNING
• When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual concrete
surface in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid
part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifica-
tions. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill
to avoid breaking out the back of the hole when entering a void or cavity.
• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
• Make sure that the wall will safely support four times the combined load of the equipment and all attached hard-
ware and components.
D
Drill hole and insert anchor (
E
)
Place wall bracket over anchor (
E
) and secure with
screw (
D
)
After repeating step one tighten all fasteners
• Tighten concrete anchor bolts firmly, but do not
overtighten. Overtightening can damage the bolts,
greatly reducing their holding power.
• Never tighten in excess of 80 in • lb (9 N.M.).
WARNING
• Concrete anchors are
not
intended for attachment to
concrete wall covered with a layer of plaster, drywall,
or other finishing material. If mounting to concrete wall
covered with plaster/drywall is unavoidable, plaster/
drywall (up to 5/8" thick) must be counterbored as
shown below. If plaster/drywall is thicker than 5/8",
custom fasteners must be supplied by installer.
WARNING
