ISSUED: 04-16-04 SHEET #: 095-9194-1
2
of
6
Visit the Westinghouse Web Site at www.westinghousedigital.com
For customer service call
1-866-287-5555
.
For Wood Stud Walls:
Use a stud finder to locate
center of stud. Drill two 3/16" (5 mm) dia. holes to a
minimum depth of 2" (51 mm). Attach swing arm to
center of wood stud using two screws (
D
).
IMPORTANT:
Make sure wall bracket is level on wall.
Remove knob from tilt/adapter plate.
KNOB
TILT/ADAPTER
PLATE
• Tighten wood screws so that wall plate is firmly
attached, but do not overtighten. Overtightening can
damage the screws, greatly reducing their holding
power.
• Never tighten in excess of 80 in • lb (9 N.M.).
• Make sure that mounting screws are anchored into the
center of the studs. The use of an "edge to edge" stud
finder is highly recommended.
WARNING
D
WOOD
STUD
WALL
WALL
BRACKET