5
Westin Automotive Products, Inc.
320 W. Covina Blvd
San Dimas, Ca. 91773
Thank you for choosing Westin products
for additional installation assistance please call
Customer Service (800) 793-7846
www.westinautomotive.com
P.N.: 75-598202-RevB
ECO #: W18-0140
DATE: 10/03/18
Optional Step:
Lights (sold separately) can be installed
in the lower corners of the bumper
using the supplied M4 hardware.
Note
: Install lights per manufacturers
instructions. See
Figure 9
.
Fig. 9
Passenger's Side
1
13
14
15
16
10. Next, install the License Plate Relocation Bracket (3) using the supplied M8 Hardware.
See Figure 10.
11.
Optional Step:
The Trailer Plug Relocator Bracket may be installed for easier access to the trailer plug. It mounts in the
stock location using the factory hardware.
Note: The Lighted Screws (6) will attach in the top two holes of the License Plate Relocator (3). Use the factory license plate
light harness to wire the Lighted Screws (6). Do so by using the supplied crimp connecters to splice the Lighted screw (6) wires
into the factory harness.
Make sure to seal them using a heat gun afterwards.
Fig. 10
Fig. 11
Align the panel to the desired fit. Drill out the indicated holes.
3
19
8
1
5
12. Installation of the Quarter Panel Closeout Panels (5) will use the supplied M6 Hardware. For installation, align the Close-
out Panel with the WJ2 Rear Bumper as shown in
Figure 11.
13. Once the panel is positioned, mark and drill the two mounting holes using a 1/4” drill bit. Then, install with the M6 Hard-
ware.
See Figures 11-13.
OPTIONAL STEP
