3. A
SSEMBLY
W
ESTFIELD
- G
RAIN
A
UGERS
MK 130 P
LUS
X
61’ - 81’
44
30259
Note:
Winch shown is positioned to use hopper on right side of auger (as determined
when standing at intake end facing discharge end). To position winch or left side
hopper use, the winch with bracket must be attached with drum up, using the
saddle pin with a hairpin.
3.13. OPTIONAL LOW PROFILE HOPPER
1. Attach
the
pivot-connector to the appropriate holes in hopper with two 5/8” x
1-1/2” bolts and locknuts.
Do not over-tighten.
Tighten snug only; these
bolts act as pivot points.
2. Loosely secure the service door with the 2 square latch-washers and 3/8”
locknuts.
Note:
These must be tightened securely after hopper assembly is completed.
3. Clean dirt from inside u-joint and flight shaft end, then insert Woodruff key.
4. Raise and support hopper tube at about 50" under spout.
5. Open service door on hopper, then bring tube and hopper together guiding
flight shaft into u-joint.
6. Secure tube to pivot-connector on hopper.
• use 7/16” x 1-1/4” bolts and locknuts
Figure 3.35
Figure 3.34
Содержание MK 130 PLUS 71
