7
Operation
1. When using for
opening exterior drains
,
pay attention to the water level (B). The
system must be full of water. Add water to
the system if necessary.
2. For drain systems with multiple openings
begin by using the drain opener closest to
clog (G) while plugging all adjacent
openings (F).
3. Repeat steps as necessary with each of
the other openings upstream until drain
system flows normally.
Using
1. Insert a CO
2
cartridge (2), as illustrated on page III, with the narrow sealed
end of the cartridge facing inside the handle (3), into the opening of the
handle (3). Position the cover (1) over top threaded handle opening and
hand-tighten.
2. To install the power disc (4) unscrew the handle
(3) from the discharge chamber (5). Put the
disc(s) over the rubber sealing (6) into the
recessed threaded opening of the discharge
chamber.
Re-assemble
by
hand-tightening
discharge chamber to the handle.
3. Screw the adaptor (7) on the discharge chamber
and insert the cup (8 or 9) as far as possible onto
the adaptor. Both cups can be used reversible. It
is important that the cup perfectly matches the
opening of the blocked drain and that it covers it
completely. A pressure-resistant sealing is
important!
4. Put the splash guard (11) on the object (toilet or
sink) and lead the drain opener through the
opening in the middle of the splash guard. You
can secure the sheet edges with duct tape.
F
B
G
