Westfalia 96 97 88, Оригинальное руководство пользователя

Страница: 20 / 26

16
Operation
The Control LED (6)
The control LED (6) turns RED under following error
conditions:

Reverse connection,

Battery voltage is lower than 3 Volt.
The condition indicator blinks between RED and
GREEN in the GLOW mode.
In the manual booster function the indicator lights up
GREEN.
Operation
– Standard Mode
In most cases the weak battery can fully recharge the
jump starter. Follow these steps to get your car started:
1. Connect jumper clamps (1) to the battery terminals.
Please ensure correct polarity. The indicators (7) will
show the voltage of the
vehicle’s battery.
2. Press ON/OFF (4), the jump starter will start to
recharge itself. Usually, it will recharge to full within
150 seconds.
3. The indicators (7) show the voltage of the jump
starter during charging.
4. Wait until the 14 V stops blinking before ignition. Do
not make ignition while the 14 V is still blinking!
5. Disconnect the jump start box and proceed a
described below in paragraph 4.
Operation
– Pre-Charge Mode
Sometimes, the weak battery cannot fully recharge the
jump starter. In this cast the control LED (6) will turn on
during charging. Follow these four steps to get your car
started: