Westfalia 91 30 18, Оригинальное руководство пользователя, Страница: 22 / 34

18
Operation
The revolution in the 1
st
gear is 0 – 400 min
-1
.
When L is visible, the 1
st
gear is selected.
H = high = 2
nd
gear 0 – 1500 min
-1
.
The revolution in the 2
nd
gear is 0 – 1500 min
-1
.
When H is visible, the 2
nd
gear is selected.
Do not change the gear while the motor is running! This will lead to
damage to the machine.

Select low gear L on the gear switch (4) for the higher torque. A
lower speed gear is generally more suitable for driving screws and
fasteners. Low rotation speed is also for drilling into non pre-worked
materials, for mixing paints, or for drilling into ceramics.

Select high gear H on the gear switch (4) for the lower torque. A
higher speed gear is for drilling in wood, metal and plastics and must
not be used for driving screws and fasteners.

Always read the documentation provided with drill bits and accesso-
ries for the recommended or maximum speed setting and use the
most appropriate gear. See ‘Technical Data’ for the maximum no
load speed of each gear.
Switching ON/OFF
WARNING: Always wear adequate personal protection equipment
when setting up and operating this machine.
To start the tool, squeeze the trigger switch (7).
Note: If the trigger switch cannot be pressed down, check that the
forward/reverse switch (6) is not set to its middle position, which locks
the device (see ‘Direction Control’).

The speed of the tool is controlled by the movement of the trigger,
the further the trigger switch is pressed down, the faster the tool will
run.

Release the trigger switch to stop the machine.