Westfalia 85 46 55, Оригинальное руководство пользователя

Страница: 30 / 38

26
Maintenance and Care
Removing and Inserting the Sanding Belt
1. Unscrew the cover locking
handle (25) and remove the
acrylic glass cover (26).
2. Unscrew both Philips screws
that fixed the sanding belt
support cover (27).
3. Remove the cover. The rear
drive wheel is spring supported.
Press the adjusting handle (49)
to push the wheel slightly
forwards in order to remove the sanding belt out of the
wheels.
4. Insert the new sanding belt onto the wheels.
5. Turn the belt with your hand and observe, if the belt runs in
the middle of the wheels or if the belt moves sideward. Turn
the adjusting handle (49) to adjust the position of the wheel
and to correct the run of the sanding belt.
6. Attach the sanding belt support cover (27) again and tighten
the cover with the Philips screws.
7. Place the acrylic glass cover onto the bracket cover (27) and
fix them with the cover locking knob (25).
Removing the Sanding Disc
The sanding disc (67) is glued to the sanding disc (70).
1. To remove the sanding disc, detach the sanding dish table
(64) and the sanding dish guard (71). Carefully remove the
used sanding disc. Remove remaining adhesive residues.
2. Stick a new sanding disc of the same diameter onto the dish.
After fixing a new sanding disc, attach the sanding dish guard
and the sanding dish table onto the sander, as explained
above.