Westfalia 82 97 39, Инструкция по эксплуатации

Страница: 11 / 14

10
2. Fix the workpiece. Preferably fix the workpiece on the drill table by using an
appropriate vice (e. g. machine vice, jaw width 100 mm, clamping range 90
mm, article 82 88 22).
3. Test the drill and mill rig on a trial basis by lowering the
feed lever (7) with the already clamped drilling machine
and inserted drill bit. Lower the drill bit up to 10 mm
above the workpieces that has to be drilled.
4. The drilling depth is shown in millimetres. Pull down the
feed lever (7) until the tip of the drill bit is flush with the
workpiece. Turn the scale of the drilling depth to the
position
0 .
5. Before each use check all screws and levers for
tightness, as well as the firm fit of the workpiece and the
drill and mill rig. Switch on the drilling machine and drill
the workpiece. Read off the drilling depth on the drilling
depth scale (2). The max. drilling depth is 50 mm.
Using the Depth Stop for Serial Drilling
1. After adjusting the drilling depth, as mentioned in the previous chapter, lower
the drilling machine with the feed lever (7) that way, so the tip of the drill bit
lightly touches the workpiece.
2. Hold the machine support in this position and press down with the other hand
the depth stop releasing button (13) until the depth stop (3) slides down all the
way. Now the machine support is locked up to this position.
3. Release the machine support and fix the workpiece (if you have not already
done).
4. Drill all the workpieces with the same drilling depth.
Hints
ƒ Secure the workpiece that way to make sure the drill bit cannot lift up the
workpiece while drilling.
ƒ
Remove all wood chips after each use and keep the working surface always
clean.
ƒ Make sure not to drill in the drill table.
ƒ When drilling irregularly shaped workpieces as well as for drilling round
material it is very important to clamp the workpiece in a vice in order to fixed it
securely in position.
ƒ By loosened the fixing screws (8), if necessary, the machine support can be
rotated on the rack around the drill table.