Westfalia 72 83 52, Инструкция по эксплуатации

Страница: 15 / 23

10
User Hints
Hints
ƒ
The winch is equipped with two safety switches, which turn the winch off on
the upper and the lower stop.
ƒ
After the cable has been extended, several turns remain on the cable drum
when the winch is turned off. This is necessary for safety reasons and de-
sired.
ƒ If the cable winch is not able to lift a weight, immediately switch off the winch
in order to avoid damage and accidents.
ƒ Ensure the load is securely fastened onto the lifting hook and keep clear of
load and steel cable during operation. Never walk underneath a raised load!
ƒ When lowering a load, please remember that the winch can run on for a few
centimetres when stopping, so always stop the winch in good time!
ƒ Pay attention at all times that the steel cable is never deflected by more than
15°.
ƒ Only use the cable winch up to its maximum load capacity. For load capacity,
see the technical data.
ƒ The motor is equipped with a temperature fuse against overheating by
overload. After a resting time for some minutes you can use the unit again.
ƒ The intermittent operation defines the proportion between the resting time and
the operating time. The intermittent operation is calculated in an ambient
temperature of 40°C within a cycle time of 10 min = 100%.
During an intermittent operation of 70% the operating time is about 7 min.
after a resting time of 3 min.
ƒ
Please note that by increasing the load the max. operating time is smaller and
the resting time longer. If the load is less heavy the operating time will be
longer.