Westfalia 109937, Инструкция по эксплуатации

Страница: 23 / 26

22
Replacing the Scraper
The scraper is located at the base of the snowthrower beneath the rotor housing.
1. Detach the worn scraper from the snowthrower by removing the 3 screws that hold it in
place. See Pic.9&10
2. Install the new scraper and fasten it securely to the snowthrower with 3 screws. See Pic.11
Replacing the Belt
Note: Determine the left and right sides of the snowthrower by standing behind the unit in the
normal operating position.
1. Remove the screws from the left panel of the snowthrower.
2. Lift the belt tension and roll the belt off the big pulley. See Pic. 12
3. Replace the belt by following instructions in reverse order. See. Pic.13
Pic.6 Pic.7 Pic.8
Pic. 9 Pic. 10
other rubber plate in the same way.( Pic.6-8)
Storage
1. Allow the unit to cool and clean the unit before storing or transporting. Be sure to secure the
unit while transporting.
2. Disconnect the extension cord from the snowthrower.
3. Inspect the extension cord closely for signs of wear or damage. Replace it if it is worn or
damaged.
4. Inspect the snowthrower carefully for worn, loose, or damaged parts. Check connections and
screws and tighten if necessary.
5. Store the unit, along with the disconnected extension cord, in a locked, dry place our of the
reach of children to prevent unauthorized use or damage. Cover loosely with a tarp for added
protection.
Pic.11 Pic.12