Westfalia 109937, Инструкция по эксплуатации, Страница: 22 / 26

21
8. Do not apply additional mand-made load to the engine since this may cause engine damage.
9. Some parts of the snowthrower may freeze under extreme temperature conditions. Do
not attempt to operate the snowthrower with frozen parts. If the parts freeze while the
snowthrower is in use, stop the snowthrower, unplug the extension cord, and inspect for
frozen parts. Free all parts before restarting or operating the snowthrower. Never force
controls that have frozen.
10. Working on pebbles, gravel or unpaved surfaces—To avoid throwing loose surface material
along with the snow, push down on the handle to raise the scraper at the base of the unit
above the pebbles or gravel.
1. The discharge chute can be adjusted by 180 degree by rotating the chute direction handle.
Rotate the handle clockwise to move the discharge chute to the left; counterclockwise to
move the chute to the right.
2. The chute deflector on the top of the discharge chute controls the height of the snowstream.
Loose both chute deflector knobs to raise or lower the deflector to the desired height of snow
you wish to throw. Tighten the knobs to secure the deflector.
Note: Do not overtighten the chute deflector knobs.
1. Do not attempt to repair the machine unless you have the proper tools and instructions for
disassembly and repair of the machine.
2. Check the shear bolts and other bolts at frequent intervals for proper tightness to ensure that
the equipment is in safe working condition.
3. After each snow removal season, run the snowthrower for a few minutes to prevent the
collector/impeller from freezing. Shut off the motor, wait for all revolving parts to stop
completely, and wipe residual ice and snow off the unit. Rotate the chute direction handle
several times to remove any excess snow.
Changing Throw Direction and Throw Height
Maintenance
Never direct the snow discharge chute at the operator, at bystanders, at vehicles or at nearby
windows. The discharged snow and foreign objects accidentally picked up by the snowthrower
can cause serious damage and personal injury.
Always orient the discharge chute in the opposite direction from where you, bystanders,
surrounding vehicles, or windows are located.
Lifetime Lubrication
Lubrication is not necessary an may damage the unit. The snowthrower is lubricated for lifetime
use at the factory before shipment.
General Maintenance Tips
WARNING
WARNING
Make sure to turn off the switch and disconnect the extension cord before
performing any maintenance task on your snowthrower.
Replacing the Rubber Plates
Note: When replacing worn rubber plates, pay close attention to carefully distinguish between the
coarse and smooth side of the plates. Place the coarse side inside and the smooth side outside.
1. Detach the worn rubber plate by removing the two sets of nuts, bolts, and washers used to
secure it.
2. Install the new rubber plate so that the coarse side faces inward and the smooth side faces
outward.
3. Insert the bolt with the small flat washer into the corresponding holes on each end of the
rubber plate. Use the large flat washer and locknut to secure the bolt on each end. Install the