Westfalia 10 92 98, Инструкция по эксплуатации, Страница: 15 / 19

10
Using
4. Pull the slide hammer (6) in even strokes backwards. This way
dents can be pulled out If necessary, perform some test runs on
an unused workpiece to make yourself familiar with the working
principle of the tool.
5. Close the air inlet valve again. The air supply is stopped and
there is no more vacuum at the suction cup. The tool can be
released from the metal sheet.
6. After use, disconnect the tool from the compressed air supply.
Air Pressure and Air Volume
ƒ Operate the air dent puller with a pressure of 6 bar. When using
higher pressure for operating the air tool than the max. permitted
pressure of 8 bar, its self life will be reduced drastically. Operate
the air dent puller using a compressor with an air suction capacity
of at least 300 l/min.
ƒ Only use air hoses with an inner diameter of at least 9 mm. When
setting up the air pressure, always keep in mind that the pressure
will decrease by approx. 0.6 bar when using a 10 m long hose
with an inner diameter of 9 mm.