Western WB-160D, Руководство пользователя и инструкции по установке

Страница: 9 / 12

Lit. No. 43575/43585/43595, Rev. 01 9 November 1, 2017
4. Install the control handle onto the end of the
control rod, as shown. Tighten the set screw.
5. Attach the clear protective cover to the hopper.
ASSEMBLY
ASSEMBLING YOUR SPREADER
1. Tires are not fully in fl ated when shipped. In fl ate
tires with a manual pump.
2. Insert the bent end of the rod through the hole in
the cross piece of the main frame. Apply a washer
to the end and slide the rod end into the gate slide.
Lock in place with the hairpin cotter as shown.
The washer should be between the hole in the
gate slide and the cotter pin.
3. Insert the rod through the main frame while sliding
the upper handle assembly down onto the main
frame. Fasten with cap screws and locknuts.
WARNING
Use safety glasses and gloves when in fl ating
and installing the tires. Use manual pump
only to in
fl ate. Refer to the tire sidewall for
manufacturer's recommended pressure. Do
not exceed the maximum in
fl ation pressure.