Lit. No. 31008/31021, Rev. 00
9
June 1, 2022
MOUNTING THE SPREADER
CHUTE ASSEMBLY
1. Install four of the provided 3/8" stainless steel
flanged cap screws through the spinner guard
holes into the rivnuts on the chute enclosure.
2. Remove and retain the cable boot bracket, dust
cover, and fasteners. Install the left and right side
chute pin ears to the chute enclosure with six
provided 3/8" flanged stainless steel cap screws.
Reinstall the cable boot bracket and dust cover.
3. Set chute aside for installation after the spreader has
been installed on the vehicle.
Left-Side
Chute Pin Ear
Spinner Guard
Right-Side
Chute Pin Ear
3/8" Flanged
Cap Screws
REMOVE SHIPPING BRACKETS AND
LOCATE COMPONENTS
The spreader is shipped from the factory with its
components secured inside the hopper and the top
screen in place. Before installing the spreader, remove the
shipping brackets and top screen, and locate components.
1.
Remove the 3/8" flanged cap screws and the
top screen brackets, and remove the top screen.
Retain the screen and fasteners for reinstallation.
2. Inside the hopper, remove the 3/8" cap screws from
the four shipping brackets (two on each side) that
secure the chute enclosure and the spinner deflector
assembly to the hopper. Set the chute enclosure and
spinner deflector assembly aside, and discard the
brackets and hardware.
3. Immediately install the provided 3/8" stainless
steel flanged cap screws in place of the shipping
bracket fasteners removed from the hopper.
Remove brackets.
