Western Leonardo System 1kW/1500/24 S, Техническое руководство

Страница: 19 / 24

Leonardo System 1kW/1500/24 S Manuale Tecnico
Leonardo System 1kW/1500/24 S Technical Manual
Rev. 5.0
02 ‐ 02 ‐ 2015
This document is the property of WESTERN CO. Srl ‐ All rights are reserved ‐ Reproduction and use of information contained within this document is forbidden without the written consent of WESTERN CO.
Srl
7
Charge and output power Table
Charge SOC level 4 , battery energy
stored is in a range between 75% ‐ 100%
of its nominal capacity. (Voltage > 27,2 V)
Output power LOAD level 4 , load power
absorption is greater than 4000W
Charge SOC level 3 , battery energy
stored is in a range between 60% ‐ 75%
of its nominal capacity. (Voltage > 24 V)
Output power LOAD level 3 , load power
absorption is is in a range between
2200W ‐ 4000W .
Charge SOC level 2 , battery energy
stored is in a range between 40% ‐ 60%
of its nominal capacity. (Voltage > 23 V)
Output power LOAD level 2 , load power
absorption is is in a range between
1200W ‐ 2200W .
Charge SOC level 1 , battery energy
stored is in a range between 30% ‐ 40%
of its nominal capacity. (Voltage > 21 V)
Output power LOAD level 1 , load power
absorption is is in a range between 200W
‐ 1200W .
Tab. 3 State of Charge and Output Power
LED STATUS table report
LED STATUS
Green LED: standard working status ‐ mode ON
LED STATUS
Red LED: 1 flash every 10 seconds – warning for overcharge status.
LED STATUS
Red LED: 2 flashes every 10 seconds – warning for low battery status.
LED STATUS
Red LED: 3 flashes every 10 seconds – warning for over –load status.
Tab. 4 LED STATUS indications
NOTE: If the inverter stops and there is no voltage on the AC ‐ OUT, because one of the three fault conditions
listed in tab. 4, you need to RESTART the device, as instruction in section START and TEST the system, point 3.