SOP Title:
WT-
GERM KILLER™ 8910UVC BODYLight™ Operation
Effective Date:
10July2020
SOP Number:
WT-SOP-01007.05
Page:
8 of 17
Western Technology, Inc.
Confidential and Proprietary
11.
EQUIPMENT OPERATION
11.1. Procedural Frequency
11.1.1. This SOP should be followed every time the UVC BODYLight is used.
11.2. Safe Equipment Handling
11.2.1. For extended life and efficacy of the UVC BODYLight always avoid rough
usage and keep the Light clean and free of material splatter, overspray,
and debris during usage.
11.2.2. It is recommended to always operate the UVC BODYLight with the Bristle
Cone in position for protective operation to all personnel and to
appropriately gauge effective kill distance.
11.2.3. Always move or carry the UVC BODYLight by the body, affixed strap, or
handle
– Never pull by a connected power cord.
11.2.4. Do not impact the Lens with hard, sharp or heavy objects, which can
cause the lens to scratch, chip, crack, or shatter.
11.2.5. Avoid setting the UVC BODYLight FACE DOWN, especially on abrasive
surfaces, which might result in chipping, scratching, abrading, or cracking
of the Lens.
11.2.6. Do not operate the UVC BODYLight without Bumpers.
11.2.7. Do not severely bend a connected cord at any point as this may cause
internal conductors to break and system failure.
11.3. Charging the BODYLight Battery Pack
11.3.1. Obtain the BODYLight Battery Charger and plug it into a compliant VAC
outlet in an Ordinary Location.
11.3.1.1.
WARNING - The charger is not explosion proof rated and
must remain outside the hazardous location when charging
the batteries.
11.3.2. Obtain the BODYLight Battery Pack and screw it into the receiving hub
on the Battery Charger until a firm contact is made and allow the Pack to
fully charge.
11.3.2.1. Note: The Hub is fitted with a Battery Pack charge indicator ring
that will glow
when the Battery Pack is in a charge cycle
and
when the Battery Pack is fully charged.
11.3.2.2. A full charge cycle takes approximately 2.5 hours.
11.3.2.3. Once the Battery Pack is fully charged, the Battery Charger will
enter into a standby mode until an additional charge is required.
