Western Star 47X 2020, Руководство по обслуживанию

Страница: 136 / 166

Approved Power Steering Fluids
Fluid Type Approved Fluid
Automatic Transmission Fluid
Dexron® III
Super ATF
TES-389
Table 1, Approved Power Steering Fluids
12. Apply a thin film of power steering fluid on the
gasket of the new filter, then attach the filter to
the filter cap and install the cap on the reservoir.
•
For filter caps with a separate retaining
ring, hand-tighten the filter, then turn it an
additional 1/4 turn.
•
For one-piece filter caps, the filter is not
threaded.
13. With the engine off, turn the steering wheel from
full left to full right three times. Add more power
steering fluid as needed.
14. Start the engine and operate the engine at idle.
Check that the power steering fluid level is be-
tween the MIN COLD and MAX HOT lines. Add
more power steering fluid if needed.
15. Turn the steering wheel from full left to full right
several times. Add fluid to the reservoir as
needed to maintain the fluid level between the
MIN COLD and MAX HOT lines.
16. Shut down the engine.
17. Raise the vehicle, remove the jack stands, and
lower the vehicle.
46–03 Drag Link Lubrication
1. Park the vehicle on a level surface, shut down
the engine, and set the parking brake. Chock the
tires.
2. Using a clean rag, wipe all dirt from the drag link
grease fittings. See
Fig. 2 .
3. Using a pressure gun and NLGI Grade 2 (8%
12-hydroxy lithium stearate grease) or NLGI
Grade 1 (6% 12-hydroxy lithium stearate grease)
chassis grease, apply clean grease at the grease
fittings until old grease is forced out of the
socket.
f462401 04/20/2020
1
2
3
4
1. Reservoir
2. Filter Cap
3. Pressure Line
4. Return Hose
Fig. 1, Power Steering Reservoir
f461072 10/07/2016
2
1
1. Grease Fitting at Pitman Arm
2. Grease Fitting at Axle Steering Arm
Fig. 2, Drag Link
Steering
46
47X and 49X Maintenance Manual, August 2020
46/2