Westermo TD-32 B, Приложение к руководству по установке

Страница: 12 / 28

12 Appendix to installation manual 6178-2203
Commands in both the TD-32 and the TD-32 B but with different result codes
Command In TD-32 In TD-32 B Note.
ATI2 <CR><LF> <CR><LF>
OK OK
<CR><LF> <CR><LF>
<CR><LF>
OK
<CR><LF>
ATI3 <CR><LF> <CR><LF>
V2.400A- V3.500-V90_2M_DLS
<CR><LF> <CR><LF>
<CR><LF> <CR><LF>
OK OK
<CR><LF> <CR><LF>
ATI5 <CR><LF> <CR><LF> (see below)
49 FD
<CR><LF> <CR><LF>
<CR><LF> <CR><LF>
OK OK
<CR><LF> <CR><LF>
ATI6 <CR><LF> <CR><LF>
RCV144Dpi Rev CA RCV336DPF-PLL L8571A Rev 43.06/43.06
<CR><LF> <CR><LF>
<CR><LF> <CR><LF>
OK OK
<CR><LF> <CR><LF>
ATI7 <CR><LF> <CR><LF>
000 OK
<CR><LF> <CR><LF>
<CR><LF>
OK
<CR><LF>
ATI9 <CR><LF> <CR><LF>
<CR><LF> <CR><LF>
” firmware build time stamp” ”firmware revision”
<CR><LF> <CR><LF>
<CR><LF> OK
OK <CR><LF>
<CR><LF>
New commands in the TD-32 B that do not exist in the TD-32
Command in TD-32: None
Relevant command in TD-32 B: +MS
Description: This command controls the modulation technique used
in a connection. To display the valid parameters enter
the command AT+MS=?. And to see the active setting
of the command enter AT+MS?