V3.8
OnTime Industrial Ethernet
U/R/T200 series Installation Guide
- 15 -
3.3.2 Normal Indication Mode
When the unit is first powered on the Switch front panel LEDs will run in normal mode. In this
condition the port LED will indicate link and traffic status.
3.3.3 Select Port Mode
The front panel will enter Select Port Mode when the Select Port button is pressed. Pressing
the Select Port button once will illuminate Port 1 LED – manual control of this port is now
available. Pressing the Select Port button a second time will illuminate Port 2 LED – manual
control of this port is now available. Each additional port can be placed into Manual mode by
subsequent pressing of the Select Port button.
If no buttons are pressed for 30 seconds the unit will return back to Normal Indication Mode.
3.3.4 Speed Button
Pressing the Speed button once selects 10M, twice enables 100M.
3.3.5 Duplex Button
Pressing the Duplex button changes the Port duplex mode from full duplex to half duplex and
vice-versa.
3.3.6 Auto-negotiation
Pressing both the Speed and the Duplex button will enable or disable auto-negotiation for the
selected port.
3.3.7 Save Button
Newly configured settings are stored in non-volatile memory when the Save button is
pressed.
Note: Manual configuration of fiber ports is not possible. These ports are configured for full
duplex connectivity and 100 Mbps.
