Section BXM‐10N‐HE3‐20A
030‐101741 Rev. B
R
10
1311IARB
Figure 12. H‐Frame Mounting
H‐frame Sliding Nut
(compress spring
and slide nut into
ends of rails)
Bolt
Washer
Pole or post
H‐frame Rail
or Channel
DETAIL A
H‐frame Sliding Nut
(slide nut into end of rail,
see DETAIL A)
H‐frame Sliding Nut
(slide nut into end of rail,
see DETAIL A)
25.2”
See Figure 27 for horizontal
distances between mounting holes.
7.
Determine next step.
If ground, power, and communica
tions cables and internal equipment will not be connected
and mounted at this time, proceed to the next step to final
ize the cabinet installation. If ground, power, and
communications cables and internal equipment will be
connected, mounted, and powered‐up at this time, skip
the next step and proceed to Paragraphs 3.7 through Para
graph 3.16 for those procedures.
8.
Close up cabinet and clean the site.
Close the Boxer door,
and lock it using a can wrench or 216 tool and an optional
padlock. Pick up any tools and materials at the installation
site, and clean the site of any trash or debris.
3.6.2
Mounting on a Wall
Follow company practices or the steps below to mount the Box
er cabinet to an approved wall (Figure 13). The approved wall
and hardware used must be able to support the combined
weight of the cabinet, the equipment mounted inside the cabi
net, plus the optional battery box (and batteries), if installed.
Westell recommends a minimum cabinet installation height of
30” from the ground. See Figure 11 for cabinet and mounting
hole dimensions.
1.
Find best wall position.
Locate the best mounting position
for the cabinet on the wall. Verify this location meets all cabi
net spacing requirements and company practices.
2.
Remove knock‐outs.
See Paragraph 3.5 (
Removing the
Knock‐outs
) to remove the knock‐outs where any cable ac
cess holes are desired.
3.
Prepare the mounting hardware.
Bring the appropriate
mounting hardware to the installation site. The hardware
must be capable of supporting the weight of the cabinet plus
the weight of the added internal equipment. Use a minimum
of 6 mounting fasteners (such as lag bolts).
