on the laser sight by pressing the button on the back of the
laser, then sight in your proposed path. Release the trigger
Safety and pull the trigger. Your pull line is now installed and
you are ready to pull your cable. It is recommended to turn the
safety back on after each Dart launch.
Velocity Control
The
LaserLine
is equipped with a velocity adjustment knob
that will allow you to slightly increase or decrease the darts
velocity. Located below the cocking knob is a knurled
adjustment knob. Turning the adjustment knob clockwise will
increase the dart velocity. Turning the adjustment knob
counter-clockwise will decrease the dart velocity.
See Figure E below.
Fig. E
NOTE: When loading the CO2, make sure the velocity
adjustment knob is not set to the maximum velocity
setting.
Before loading the CO2, turn the velocity knob all the way
to the right until it stops, then back it off approximately 2
full turns. This will prevent the CO2 from leaking and also
allow the valve to seat and seal correctly. Once the CO2
cartridge is installed, you can turn the velocity adjustment
to the preferred velocity position.
WARNING
Increase
Velocity
(clock wise)
Decrease
Velocity
(counter clock wise)
Содержание LaserLine
Страница 13: ...Elevation Adjustment screw Windage ...