6
STEP 1
Install the Front stabilizer tube (2) and Rear stabi-
lizer tube (3) to the Main frame (1) fixing with the
Bolts (13), Arc washers (14) and Nuts (15).
STEP 2
While another person holds the Upright (4) near
the Frame (1), connect the Extension Wire (18) to
the sensor Wire (17).
Next, connect the Resistance Cable (8) to the Low-
er Cable (16) in the following way:
• See drawing A. Pull upward on the metal bracket
on the Lower Cable (16), and insert the tip of the
Resistance Cable (8) into the wire clip inside the
metal bracket as shown.
• See drawing B. Firmly pull the Resistance Cable
(8) upward and slide it into the top of the metal
bracket as shown.
• See drawing C. Using pliers, squeeze the prongs
on the upper end of the metal bracket together.
Push the Wires and cable (16, 8, 18, 17 ) down-
ward into the Frame (1).
Than place the upright (4) into the Frame (1).
Tip: Do not pinch the wires and cables. Insert
the Upright (2) into the Frame (1). Attach the
Upright with 4 Screws (19) and 4 Washers (14).
STEP 3
Assemble the Pedals (10L, 10R) to the Crank (36L,
36R).
Note: The right pedal should be fixed clockwise.
However, the left pedal should be fixed counter-
clockwise.
A
B
C
9
6
6
9
8
16
16
8
Metallic
support
Metallic
support
