3. Carefully rotate the Console Base (45) to the posi-
tion shown. Secure the Console Base with two
Console Base Bolts (91), two Console Base
Washers (90), and two Console Base Nuts (11) as
shown.
Refer to the inset drawing.
Tighten all four
Console Base Bolts (91) and Console Base Nuts
(11) as tightly as possible. Carefully lift up and
push down on the handrails to make sure that
the Console Base (45) does not move. Regularly
inspect and tighten all four Console Base Bolts
and Console Base Nuts.
4. Attach the Frame Guide (66) and the Frame Guide
Spacer (46) to the left side of the Frame (21) with
two Guide Screws (25). Note: Be careful not to over-
tighten the Guide Screws.
Make sure that the thick
end of the Frame Guide is at the bottom.
5. Remove the backing from the Adhesive Clip (2).
Press the Adhesive Clip onto the base of the Upright
(37) in the indicated location. Press the Allen
Wrench (35) into the Adhesive Clip.
6.
The Console (49) requires two "AA" batteries (not
included); alkaline batteries are recommended.
Open the Battery Cover (48) as shown. Press two
batteries into the battery compartment, with the neg-
ative ends of the batteries (marked ÒÐÓ) touching the
springs. Close the Battery Cover.
7. Make sure that all parts are properly tightened
before you use the treadmill.
To protect the floor or
carpet from damage, place a mat under the
treadmill.
6
3
4
5
11
6
HOW TO LOWER THE TREADMILL FOR USE
1. Hold the upper end of the treadmill with your right hand
as shown. Using your left hand, slide open the storage
latch. Pivot the treadmill until the frame guide and the
foot rail are past the storage latch.
2. Hold the treadmill firmly with both hands, and lower the
treadmill to the floor.
To decrease the possibility of
injury, bend your legs and keep your back straight.
Opened
Storage
Latch
Frame
Guide
45
90
11
11
91
91
90
21
35
48
49
Batteries
37
2
66
46
Thick end
25
39
11
39
11
45
Handrails
