1. With the help of a second person, carefully lay the
treadmill on its side. Position one of the Base Legs
(55) on the base of the Upright (37) as shown. Make
sure that the Base Leg Pads (31) and the Wheel
(34) are in the indicated positions. Attach the Base
Leg with two Base Leg Bolts (28), two Base Leg
Washers (68), and two Base Leg Nuts (61).
Carefully turn the treadmill onto its other side.
Assemble the other Base Leg (55) as described
above.
With the help of a second person, carefully raise the
treadmill to the upright position so the Base Legs
(55) are resting flat on the floor.
2. Hold the treadmill firmly with both hands, and lower
the treadmill to the floor.
To decrease the possibili-
ty of injury, bend your legs and keep your back
straight.
2
1
5
12
ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
¥
Assembly requires two people.
¥
Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
¥
As you assemble the treadmill, be sure that all
parts are oriented as shown in the drawings.
The following tools (not included) are required
for assembly:
¥ Two (2) adjustable spanners
¥ One (1) phillips screwdriver
MAINTENANCE AND TROUBLE-SHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please call our Customer Service Department.
PROBLEM: THE POWER DOES NOT TURN ON
SOLUTION:
a. Make sure that the power cord is plugged into a properly earthed outlet. (See HOW TO PLUG IN
THE POWER CORD on page 7.) If an extension cord is needed, use only a 14-gauge cord of
five feet (1,5 m) or less in length.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c. Check the circuit breaker located on the treadmill
frame near the power cord. If the switch pro-
trudes as shown, the circuit breaker has tripped.
To reset the circuit breaker, wait for five minutes
and then press the switch back in.
PROBLEM: THE POWER TURNS OFF DURING USE
SOLUTION:
a. Check the circuit breaker located on the treadmill frame near the power cord (see the drawing
above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. If the treadmill still will not run, please call our Customer Service Department.
PROBLEM: THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION PROPERLY
SOLUTION:
a. Check the batteries in the console. If the batteries need to be replaced, see assembly step 6 on
page 6. Most problems are the result of drained batteries.
b. Remove the six screws from the hood. Carefully
remove the hood. Locate the Reed Switch (8) and
the Magnet (14) on the left side of the Pulley (5).
Turn the Pulley until the Magnet is aligned with the
Reed Switch.
Make sure that the gap between
the Magnet and the Reed Switch is about 1/8Ó
(3 mm).
If necessary, loosen the Clip Screw (9) and
move the Reed Switch slightly. Retighten the
Screw. Re-attach the hood, and run the treadmill for
a few minutes to check for a correct speed reading.
Tripped
Reset
Tripped
Reset
c
14
8
9
Top View
1/8Ó
5
28
68
31
55
34
37
61
