Weslo PURSUIT S 2.8, Руководство пользователя

Страница: 7 / 20

7
4. Turn the Seat Knob (9) counterclockwise and
remove it from the Frame (1). Next, insert the
Seat Post (5) into the Frame. Adjust the Seat
Post to the desired height and insert the Seat
Knob through the indicated hole in the Frame
into one of the adjustment holes in the Seat
Post. Then, turn the Seat Knob clockwise until it
is tight. Make sure the Seat Knob is firmly
engaged in one of the adjustment holes in
the Seat Post.
4
5
1
9
Hole
Adjustment
Holes
5
5. While another person holds the Upright (13)
near the Frame (1) as shown, connect the
Extension Wire (23) to the Reed Switch Wire
(39). Next, connect the Resistance Cable (19)
to the Lower Cable (29) in the following way:
• See drawing A. Pull up on the metal bracket
on the Lower Cable (29), and insert the tip of
the Resistance Cable (19) into the wire clip
inside of the metal bracket as shown.
• See drawing B . Firmly pull the Resistance
Cable (19) upward and slide it into the top of
the metal bracket as shown.
• See drawing C . Using pliers, squeeze the
prongs on the upper end of the metal bracket
together.
Push the Wires (23, 39) and the Cables (19, 29)
downward into the Frame (1).
Next, insert the Upright (13) into the Frame (1).
Do not pinch the wires and cables. Attach the
Upright with three M8 x 15mm Button Screws
(34) and three M8 Split Washers (42).
A B C
29
19
19
Metal
Bracket
Metal
Bracket
Do not pinch
the wires and
cables during
this step
34
39
19
29
42
34
23
13
1
42
Meijer.com