Weslo PURSUIT E25, Руководство пользователя

Страница: 6 / 16

6
4. The Console (7) requires one “AAA” battery (not
included); an alkaline battery is recommended.
See inset drawing. Remove the battery door
from the back of the Console and insert the bat-
tery into the Console. Make sure that the bat-
tery is oriented as shown by the diagram
inside the battery compartment. Then, reat-
tach the battery door.
Next, plug the Reed Switch Wire (28) fully into
the socket on the back of the Console (7).
Slide the Console (7) onto the console plate.
Note: The Console is held by friction; it does not
snap into place.
Battery Door
Battery
7
28
Console
Plate
4
3. Remove all parts from the Pivot Axle (3). Insert
the Pivot Axle into the Frame (1). Align the hole
in the center of the Pivot Axle with the hole in
the center of the Frame. Tighten an M5 x 10mm
Machine Screw (32) into the Frame and the
Pivot Axle.
Slide the Left and Right Handlebars (40, 41)
onto the ends of the Pivot Axle (3). Slide an M8
Flat Washer (38) onto each end of the Pivot
Axle, and then thread an M8 Locknut (9) onto
each end of the Pivot Axle. Tighten each
Locknut until at least two threads on the end of
the Pivot Axle extend past the Locknut. Make
sure that the Handlebars move freely .
Press a Pivot Cap (50) onto each end of the
Pivot Axle (3).
Apply a small amount of liquid soap to the upper
end of each Handlebar (40, 41). Slide a Foam
Grip (42) onto each Handlebar. Make sure that
there is a Handlebar Cap (55) in each
Handlebar.
40
1
32 Hole
38 9
41
55
55
42
42
3
50
9
38
50
3