6
11
54
40
54
40
2
56
10
2
4. Hold the Handlebar Post (2) in the position shown.
Refer to the inset drawing. Make sure that the indi-
cated nut is threaded fully onto the connector on the
Extension Cable (58). Align the slot in the nut with
the slot in the connector. Next, insert the tip of the
Resistance Cable (10) into the indicated opening,
pull up on the Resistance Cable, and insert the
Resistance Cable into the open end of the connec-
tor. Turn the nut counterclockwise one or two turns
until the Resistance Cable is held snugly in the con-
nector. Note: If there is a clear plastic sleeve on the
Extension Cable, position the sleeve so that it cov-
ers the connector
Connect the Reed Switch Wire (13) to the Extension
Wire (56).
Making sure not to pinch the wires or cables,
slide the Handlebar Post (2) onto the Frame (1).
Attach the Handlebar Post with three M10 x 19mm
Button Head Screws (25) and three M10 Split
Washers (26).
4
2
25
25
10
26
26
26
56
13
1
58
2. Hold the Console Plate (11) near the Handlebar Post
(2) as shown, and feed the Resistance Cable (10)
down through the Handlebar Post.
Next, feed the Extension Wire (56) up through the
indicated hole in the Console Plate (11).
Attach the Console Plate (11) to the Handlebar Post
(2) with two M6 x 8mm Button Head Screws (40)
and two M6 Split Washers (54).
3. Connect the Extension Wire (56) to the wire on the
Console (8). Next, attach the Console to the
Console Plate (11) with four Console Screws (20).
Press the Resistance Knob (9) onto the Resistance
Control (10).
3
9
8
11
56
20
46
1
48
48
47
24
24
1. Hold one of the Stabilizers (46) against the saddle
on the rear of the Frame (1).
Make sure that the
Stabilizer is turned so the square holes are fac-
ing away from the saddle.
Attach the Stabilizer
with two M8 x 63mm Carriage Bolts (47) and two
M8 Nylon Locknuts (24).
Attach the other Stabilizer (not shown) to the front
of the Frame (1) in the same way.
1
58
10
Connector
Nut
Slot
