9
12.
Make sure that all parts are properly tightened before
you use the treadmill.
Note: Extra hardware may be in-
cluded. Keep the included hex keys in a secure place;
the large hex key is used to adjust the walking belt (see
page 18). To protect the floor or carpet, place a mat
under the treadmill.
10. Lower the Handrails (13, 40) until they are touching the
floor.
See drawing 10a. Position the Handrails (13, 40) so the
treadmill Frame (96) is centered between them.
Firmly tighten the four 3” Bolts (58) and the two 4”
Frame Bolts (54).
Be careful not to overtighten the
Bolts.
13
40
40, 13
96
96
Top View
10
10a
58
54
11. Remove the knob from the pin.
Make sure that the col-
lar and the spring are on the pin.
Insert the pin into the
Latch Housing (46), and then tighten the knob back onto
the pin.
46
Pin
Spring
Knob
Collar
11
38
67
84
65
40
9. Press the Wire Harness (65) into the indicated track in
the Console Base (67). (Note: If there is a cylinder on the
Wire Harness that will not fit into the track, press as
much of the Wire Harness as possible into the track.)
Next, insert the excess Wire Harness into the large hole
in the side of the Right Handrail (40).
Securely tighten
the nylon tie to prevent the Wire Harness from slip-
ping,
and then cut off the end of the nylon tie.
Attach the Access Door (84) to the Console Base (67) with
the 3/4” Screw (38).
See step 5. Tighten, but do not overtighten, the 1”
Bolts (43) and the 4” Handrail Bolts (78).
9
Tie
Track
