ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dis-
pose of the packing materials until assembly is completed. In addition to the included allen wrench, assembly
requires a phillips screwdriver, an adjustable wrench and scissors .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor-
mal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply
wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
5
1
81
44
38
33
39
4
53
1. With the help of a second person, raise the Uprights (38)
to the position shown. During this step and step 2, be
careful not to pull on or damage the Wire Harness (53)
in the right Handrail (4).
Insert one of the Base Legs (44) into the right Upright
(38), with the Base Leg Pad (33) in the indicated position.
Using the included Allen Wrench (81), attach the Base
Leg with a Base Leg Screw (39). Attach the other Base
Leg (not shown) to the left Upright in the same way.
Note: A replacement Base Leg Pad (33) may be included.
If a Base Leg Pad becomes worn and needs to be
replaced, use the replacement Base Leg Pad.
2. Hold a Handrail (4) against the left Upright (38) as
shown. Important: If you are shorter than 5’ 8”, align
the upper two holes in the Handrail with the holes in
the Upright; if you are 5’ 8” or taller, align the lower
two holes. Attach the Handrail and a Handrail Spacer
(63) to the left Upright with two Handrail Bolts (1), two
Handrail Washers (80), and two Handrail Star Washers
(2) as shown. Loosely thread the two Handrail Bolts;
Do not tighten the Handrail Bolts yet.
Hold the Right Handrail Spacer against the right Upright
(38) and feed the excess Wire Harness (53) into the right
Upright. Make sure the right and left Handrails (4) are
at the same height. Attach the right Handrail and
Handrail Spacer to the right Upright with two Handrail
Bolts (1), two Handrail Washers (80), and two Handrail
Star Washers (2). Loosely thread the two Handrail
Bolts; Do not tighten the Handrail Bolts yet. Be care-
ful not to pinch the Wire Harness (53). Remove the tie
from the Wire Harness and the right Handrail.
Extension Leg Screw (39)–2
Latch Screw/Rack Screw (14)–14
Handrail Washer (80)–4
Console Screw (3)–4
Handrail Star
Washer (2)–4
Handrail Bolt (1)–4
2
80
38
53
Tie
4
4
38
53
80
63
63
1
2
1
2
