4
ASSEMBLY
1. Insert the end of the Rear Stabilizer (34) into the Frame (46). Attach
the Rear Stabilizer to the Frame with the four M5 x 12mm Screws
(56).
2. Turn the Front Stabilizer (59) so the indented holes are facing the
floor. Attach the Front Stabilizer to the Frame (46) with two M8 x
48mm Carriage Bolts (57), two M8 Zinc Washers (43), and two Acorn
Nuts (12).
3. Remove the three 8mm Zinc Locknuts (36) from the underside of the
Seat (40). Attach the Seat to the top of the Seat Post (41) with the
three Locknuts.
Insert the Seat Post (41) into the Frame (46). Align one of the holes
in the Seat Post with the hole in the Frame. Insert the Seat Knob
(45) into the Frame and the Seat Post, and tighten the Seat Knob
into the Frame.
Make sure to insert the Seat Knob through one of
the holes in the Seat Post; do not insert the Seat Knob under
the Seat Post.
4. Apply a small amount of grease to the Pivot Shaft (17). Slide the
Pivot Shaft into the Frame (46) and center it. Slide the Left
Handlebar (10) onto the left end of the Pivot Shaft. Slide the Right
Handlebar (not shown) onto the right end of the Pivot Shaft. Attach
an M8 Zinc Washer (43) and an 8mm Zinc Locknut (36) to each end
of the Pivot Shaft.
1
56
34
46
12
57
59
36
40
41
45
46
43
43
46
2
3
46
17
10
36
43
4
Assembly requires two people.
Place all parts of the WESLO 605s in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed. Read through all steps before
beginning. During assembly, make sure that all parts are oriented as shown in the drawings.
Assembly requires the included tool and grease packet, an adjustable wrench , a rubber
mallet , a hammer and a phillips screwdriver .
