18
MaIntenanCe
(Cont’d)
• Make sure powerhead is disconnected
from wand. Then check for blockage
in nozzle connection (B).
• There is an additional panel on the
bottom of the powerhead (C). This
opening provides a secondary place
to check and clear blockage.
Powerhead Blockage
• If the nozzle becomes clogged, use
the following procedures to check for
and clear the blockage.
• If blockage is severe enough the
powerhead will shut off. After the
blockage is cleared you must push
the overload Protection reset button
(a) before the powerhead will
operate again.
