Page 8
ENGLISH
III. Installation and Use
a. Connect the Snap Hook
Connect the snap hook on the lanyard to
ONLY to the back D-ring of the harness.
Do not connect to any other part of the
harness."
b. Connecting to an Anchorage
Connect the snap hook on the rope
lifeline to the anchor
Warning:
The rope grab should be positioned to limit potential free fall to the
shortest possible distance, but in no case more than 6’ per ANSI Z359
and OSHA requirements.
c. Connecting the Rope Grab to the lifeline
Ensure the rope grab is in the “UP” position as indicated on the
device. The “UP” end of the rope grab must be oriented towards the
anchorage when installed onto the lifeline.
d. Test the Rope Grab
Test the operation of the rope grab by pulling down on the lanyard.
You must not be able to pull the rope grab down the lifeline or adjust
it without raising the lanyard connection handle.
e. Positioning the Rope Grab on the lifeline
Squeeze the lanyard connection handle to release the rope grab
from its current position on the lifeline. Release the lanyard
connection handle to the desired new position and tug on the
lanyard to ensure it locks on the lifeline. Keep a minimum of 6 ft.
Содержание UPGEAR L242 Series
