CONCRETE MOUNTING
drill
.875 inch (22 mm) Ø
9 inches (229mm)
min from an
y edge
7 inches
(178mm) min
- Use a proper drill & bit for concrete (SDS drill bit).
- Drill a 0.875 inch (22 mm) hole no less than 3 to 3.5 inches (76mm-89mm) deep
9 inches(229mm) away from any edge.
- Hole must be straight & perpendicular to surface.
- Hole must be free of debris.
- Concrete strength must be at least 3000psi (20.7MPa) and no less than 7 inches
(178mm) thick.
- Drop expansion sleeve into hole.
- Use the Setting Tool by placing it in the hole resting on the expansion sleeve. Tap
tool until the inner blue sleeve is at the bottom of the expansion sleeve.
- Place swivel over the hole and install the bolt provided.
TAP!!!
Torque Range:
30 to 40 ft-lbs
(22-30Nm)
Setting Tool
(A570005)
Expansion
Sleeve
3 in
ch
es min a
nd 3.5 in
ch
es m
ax
(76mm-89mm)
Em
be
dm
en
t D
ep
th
Page 4
MODELS: A570002, A570004 & A570005
