Page 13
6. Make sure that the conductive rubber boot is
secure on the probe pin.
7. Hold the Pen Probe vertically and place the
rubber tip on the sample.
8. Apply pressure and compress the pogo pin until
the probe body is about 1/8” of an inch from the
rubber boot. This would provide the sufficient
pressure for correct contact force.
9. Apply to test voltage from your meter to read the
sample volume resistance per ANSI/ESDA 11.12.
10. Note: Volume resistance is shown as the reading
from the meter (in ohms) divided by the material
thickness and shown in ohm-cm or ohm-inch.
