Wenshing RD-710, Руководство пользователя

Страница: 4 / 9

http://www.wenshing.com.tw ; http://www.rf.net.tw
RD-710 Instruction Manual P.4
RD-710 Control Mode List
Remote Controller
Model No.
Dip Switch
Dial Code
Relay Mode
TX-F01
(RD-710 General type only)
1 ON Single point control( By Hand)
1
，
3 ON Two-point control(By Hand)
2
，
3 ON Automatically decrease, power
2 ON
Single point control
(Automatically decrease, power)
TX-F02
(RD-710 General type only)
1 ON Two-point control(By Hand)
2 ON
Two-point control(Automatically
decrease, power)
TX-F04
4 ON Roll-up door mode
2
，
4 ON Lift Mode
1
，
4 ON Automatically decrease mode
1
，
2
，
3 ON Single point control
RD-710 Installation Steps
1. After you open box, please check whole accessories are complete.
(Host*1pcs, Remote controller *2pcs, Fix stand*1pcs, wire*1pcs)
2. Please check motor power supply to avoid danger.
3. Please put wire installed in the motor wiring plate according to the wiring
drawing on manual.
4. After fix the host on the wall, please connect the wire.
5. Open motor power supply. If power function is normal, it is meaning you
finished assemble.
6. If it still has problem, please check following:

Wire connection is correct

Voltage is the same as motor

Dip code is the same.
7. If you still have problem on using, please contact disruptor.