Wenglor weCat3D MLSL, Руководство по эксплуатации

Страница: 55 / 71

55 2D/3D Profile Sensors
Pin function • Profile enable: Input function which enables profile recording for as long as the signal
is applied.
NOTE!
In combination with the “fixed” mode, the “profile active” pin function is used to
start the specified number of profiles. If the signal remains continuously active,
the sensor transmits a multiple of the defined number of profiles (see also
“Number of Profiles” under “Trigger Settings” in the “Profile Display” menu).
Pin function • Encod. reset: Input function for resetting the internal encoder counter to “0”.
Internal load Connects an internal resistor to the input (pull-down).
Internal load of 2 mA (on/off).
Input function Determines whether the input responds to supply voltage or 0 V.
This makes it possible to invert any pin function.
Output Sets the output’s polarity (push-pull, PNP, NPN).
Output function The output can be configured as normally open (NO) or normally closed (NC).
NOTE!
The above listed functions can be set individually for each of the 4 configurable I/Os
(with the exception of “Encod. E1+E2” which is limited to I/O1 in combination with I/O2).
7.2.5 uniVision web
In the "Smart WeCat3D" operating mode, a link to uniVision web is displayed on the website. This website can
be configured by the user and is used to display the results of the profilde analysis. For further information
please see the operating instructions for the uniVision software DNNF012/DNNF020.