34
wTeach2 Configuration Software
8.3 Events
Events are diagnostic information that is standardized by IO-Link and exchanged between the IO-Link master
and the device. The following events are supported:
Name
Eventcode
Type
Specification
Device error – unknown error
0x1000
Error
IO-Link
Short circuit – check installation
0x7710
Error
IO-Link
Supply voltage too low – check tolerances
0x5111
Warning
IO-Link
9. wTeach2 Configuration Software
For information on installing and connecting the software and its structure, as well as information on the gen-
eral functions, see the wTeach operating instructions. They can be found online in the download area under
order number DNNF005.
10. NFC
The devices can be set up and their parameters can be configured via the NFC interface with the help of an
Android smartphone and wenglor’s "Sensor Configurator" app. Process data cannot be read out via NFC but
they’re available via IO-Link.
The wenglor app can be downloaded free of charge from the Google Play Store. Download the app and
follow the installation instructions.
Scan the code below to access the wenglor app directly.
The settings are selected via the app and are then transmitted to the sensor.
With the "Read" or "Write" mode activated, hold the smartphone’s antenna just above the sensor’s active NFC
sensing face.
NOTE!
• NFC antenna position varies from one smartphone to the next.
• Refer to the smartphone’s operating instructions in order to determine the antenna’s
exact position
