Wenglor TIF352U0089, Руководство по эксплуатации

Страница: 16 / 31

16 Overview of Functions
6.2. Function Definitions
Designation Function Page
run Display mode 19
PInF Set pin function (analog or switching output) 19
AnA Adjust analog voltage or current output 19
A.Lo Temperature which corresponds to 4 mA or 0 V at the analog output 20
A.hI Temperature which corresponds to 20 mA or 10 V at the analog output 20
SP1 Switching point or switching temperature 1 21
OFn1 Select switching logic, for SP1 (PNP or NPN) 21
SL1 Select output function, for SP1 (NC or NO) 21
SP2 Switching point or switching temperature 2 22
OFn2 Select switching logic, for SP2 (PNP or NPN) 22
SL2 Select output function, for SP2 (NC or NO) 22
EP Expert menu 23
Lasr Set laser function (laser on or off) 23
d.U Select temperature unit of measure (degrees Celsius or Fahrenheit) 24
EF Adjust emission factor 24
S.EF. Teach in emission factor 24
rESP Adjust response time 25
Ser.O Continuous temperature read-out on or off 25
rES Reset: restore default settings 26
6.3. Menu Structure
Action Procedure
Enable
Enabling takes place after pressing and holding the M key for roughly 5 seconds.
After 5 seconds, the M key LED starts blinking and the sensor is in the configuration
menu.
Navigation
After enabling, you can navigate through the configuration menu by briefly tapping
the M key repeatedly. The next menu item appears at the display each time the key
is tapped.
The current setting in the submenu can be displayed by acknowledging with the
+ key. If the + key is pressed once again, the respective setting is changed.
Change the setting
If a submenu has been accessed, the current setting is displayed after acknowledg-
ing with the + key. If the + key is pressed again, the value is changed or the numeric
value is increased.
Scrolling quickly through the values can be initiated by pressing and holding the key
for more than 3 seconds.
After scrolling to the last possible setting for the respective submenu (e.g. 350° C),
the values start over again from the beginning (e.g. –25° C). A brief pause in scrolling
upon reaching the first setting (e.g. –25° C) indicates that the lowest value has been
reached.
Save
Pressing the M key not only advances the display to the next menu item: values
changed with the + key in the respective submenu are saved at the same time as
well. If the M key is pressed when a submenu is open, the display is returned to the
configuration menu.