17
Attach Wing Panels (continued)
5. Align the seam of the adjacent wing panels with the seam of the center panels.
The panels should also be aligned along the top edge.
6. Attach the wing panels to the tower frame.
a. With the wing panels in position and square to the tower frame using a 9/32" drill bit, drill a hole
through the inside panel surface only into each panel at each marked location.
Do not drill through the panel surface on the other side.
b. Clean away any wood shavings from drilling.
c. Attach the wing panels to the rotating hinges using 5/16-18 x 1" hex head tapping screws.
7. Attach trim to the outer edges of the wing panels as indicated on the installation drawings.
Tower Installation (continued)
Do not over tighten the screws,
damage to the panels could result.
Drill through the upper panel surface only.
Do not drill through the lower panel surface
on the other side.
!
CAUTION
!
CAUTION
5/16-18 x 1"
Tapping Screws
5/16-18 x 1"
Tapping Screws
Align
seams
Drill through the upper panel surface only.
Do not drill through the lower panel surface.
Align
tops
Trim
Strip
Trim
Strip
