IMPORTANT:
Servicing a double-insulated product requires extreme care and knowledge of the system, and
should be done only by a qualified service personnel using identical replacement parts. Always use original factory
replacement parts when servicing.
1. POLARIZED PLUGS. To reduce the risk of electric shock, this equipment has a polarized plug (one blade
is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the
extension cord, reverse the plug. If it still does not fit, use a correct polarized extension cord or contact a qualified
electrician to install the proper outlet. DO NOT modify the machine plug or the extension cord in any way.
2. GROUND FAULT CIRCUIT INTERRUPTER PROTECTION (GFCI). This pressure washer is provided
with a ground-fault circuit-interrupter (GFCI) built into the plug of the power-supply cord. This device provides
additional protection from the risk of electric shock. Should replacement of the plug or cord become necessary,
use only identical replacement parts that include GFCI protection.
3. SERVICE AND REPAIR. To avoid danger, electrical appliances must only be repaired by qualified service
technician using original replacement parts; otherwise this may result in considerable damage to the user.
GUIDELINES FOR EXTENSION CORDS
Use of an extension cord with this product is NOT RECOMMENDED. If an extension cord must be used, use
only a UL-, CSA- or ETL-rated extension cord that are intended for outdoor use to prevent electric shock. These
cords are identified by a marking, “Acceptable for use with outdoor appliances, store indoors while not in use.”
1. Only use extension cords that can handle the voltage and amperage rating of this product. The extension cord
must be 14 gauge or heavier, and the length must not exceed 25 feet.
2. Examine extension cord before use. Make sure your extension cord is properly wired and in good condition.
Always replace a damaged extension cord or have it repaired by a qualified person before using it.
3. Do not abuse extension cord. Do not pull on cord to disconnect from receptacle; always disconnect by pulling on
plug. Disconnect the extension cord from the receptacle before disconnecting the product from the extension cord.
Protect your extension cords from sharp objects, excessive heat and damp/wet areas.
4. Use a separate electrical circuit for your tool. This circuit must not be less than a 12-gauge wire and should be
protected with a 15A time-delayed fuse. Before connecting the motor to the power line, make sure the switch is in
the OFF position and the electric current is rated the same as the current stamped on the motor nameplate. Run-
ning at a lower voltage will damage the motor.
DOUBLE-INSULATED TOOLS
Your pressure washer electrical system is double insulated, where two systems of insulation are pro-
vided instead of grounding. Double insulated tools do not need to be grounded, nor should a means
for grounding be added to the product.
ELECTRICAL SAFETY RULES
6
WARNING – Risk of Electrocution
• Inspect cord before using – Do not use if cord is damaged.
• Keep all connections dry and off the ground. Wear rubber boots to reduce the risk of electric shock.
• Do not touch plug with wet hands. Do not immerse the unit in water.
Содержание PW19
Страница 14: ...14 EXPLODED VIEW PARTS LIST...
