![background image](http://html1.mh-extra.com/html/wen/pl1326/pl1326_instruction-manual_956362017.webp)
MAINTENANCE
ADJUSTING THE INFEED/OUTFEED EXTENSION TABLES
For best results and to minimize snipe, we recommend setting the infeed and outfeed tables so that the end of each
extension table is about 1mm above the top of the main table.
1. Locate the table elevation adjustment screw and nut on each side of the table, next to the hinge. Raise the table
to expose the screw and nut.
2. Using a wrench and screwdriver, loosen the screw while holding the nut steady. Keep track of the number of
turns applied to each screw. Make sure that the screws on the left and right sides of the table are turned the same
number of times.
3. When both screws are adjusted to the height you want the table to be, tighten down the nut against the base of
the planer while holding the screw head steady. Repeat for the other screw.
4. Test the table height. If adjustments need to be made, repeat steps 2 to 3 as needed, ensuring that both screws
have been turned the same number of times.
5. Repeat steps 1 – 4 for the other table until you are satisfied with the height.
6. Test the adjustments on a scrap piece of wood, making further adjustments as necessary until you are satisfied.
CARBON BRUSH INSPECTION & REPLACEMENT
Brush life depends on the load of the motor. Regularly inspect
brushes after 100 hours of use. Brushes are located on either
side of the planer motor, on both the front and rear side of the
planer. Loosen brush cap (Fig. 12 - 1) and carefully remove
brush from motor. Replace brushes if the spring is damaged.
Replace brushes if the carbon is worn down to 3/16” long or
shorter. Tighten brush caps after replacement. Both brushes
should be replaced simultaneously. Replacement brushes can
be purchased from
wenproducts.com
(part no.
PL1326-189
).
LUBRICATION
The motor and cutterhead bearings are sealed and need no lu-
brication. Keep the elevation leadscrew chain (located under the
bottom of the planer) lubricated with a dry chain lubricant. Do
not over-lubricate.
CLEANING THE PLANER
Keep planer clean of any wood chips, dust, dirt or debris.
We strongly recommend always using a dust collection
system.
Make sure to clean out the planer after every use.
After 10 hours of operation, the drive chains and sprockets should have wood chips, dust and old grease removed.
While wearing ANSI-Z87.1-approved safety glasses, use a couple puffs of compressed air (do not exceed 50 PSI)
to blow dust and chips out of the gearbox and drive chains.
Use common automotive bearing grease to lubricate all drive chains and sprockets. Spray the gearbox with a light
coat of dry lubricant. Clean the table and infeed / outfeed rollers using a soft, damp cloth. Do not use any waxes,
oils or solvents on the table.
NOTE:
The buildup of dust, wood shavings, and other debris can significantly shorten the planer’s useful life. Keep
your planer clean! Failure to do so will void the warranty.
Fig. 12
1
17