![background image](http://html1.mh-extra.com/html/wen/msa330/msa330_instruction-manual_956483010.webp)
INSTALLING THE HANDLE
Secure the handle (Fig. 5 - 1) to the side of the stand
without wheels, using two screws, flat washers, lock
washers and hex nuts. Tighten the hex nut. Repeat for
the other handle.
INSTALLING THE MOUNTING BRACKETS
With the locking handle (Fig. 6 - 1) in the unlocked po-
sition, hook the bracket onto the stand’s main frames.
Lock the brackets into place by gently pressing down
the locking levers.
CHECKING & ADJUSTING CLAMPING
PRESSURE
The clamping pressure of each saw mounting bracket
should be checked before it is attached to a miter saw.
To Check The Clamping Pressure:
When fitted across the two main frames with the lock-
ing handle in the down (locked) position, the bracket
should be firm and exhibit no signs of movement.
Avoid using excessive force to deploy the locking lever
to the down position. Gently pressing the lever down-
wards with the palm of your hand should be all the
force needed to operate the locking lever.
To Adjust The Clamping Pressure:
1. Turn the clamp upside down.
2. Loosen the lock nut (Fig. 7 - 1).
3. Turn the adjustment screw (Fig. 7 - 2) clockwise to
increase the clamping pressure. Turn the screw coun-
terclockwise to decrease the clamping pressure.
4. Tighten the lock nut when the clamping pressure is
at the satisfactory level. Adjust for both saw mounting
brackets.
ASSEMBLY & ADJUSTMENTS
Fig. 5
Fig. 6
Fig. 7
1
1
1
2
10
Содержание MSA330
Страница 15: ...NOTES 15...
Страница 16: ...THANKS FOR REMEMBERING V 2019 06 21...