Wen BA1411, Инструкция по эксплуатации, Страница: 20 / 32

TURNING THE SAW ON / OFF
The bandsaw can be powered ON and OFF by pressing the ON / OFF
switch (Fig. 25 - 1).
The ON / OFF switch can also be disabled and locked by inserting a
padlock through the hole in the ON button (Fig. 25 - 2). This prevents
accidental start-ups by unauthorized operators. The padlock should
have a shaft diameter of 0.12" - 0.15".
USING THE MITER GAUGE
1. Place the miter gauge into the slot on the table (Fig. 26 - 1).
2. Loosen the knob on the gauge to set a new miter angle (between 0
and 60 degrees).
3. Tighten the knob firmly before cutting begins.
NOTE: A 0° cut is a straight cut that is perpendicular to the blade.
USING THE FENCE (FIG. 27)
The fence acts as a guide for making straight cuts. Position the fence
onto the work table with the side face parallel to the blade. Adjust the
distance of the fence to the blade depending on the length you would
like to cut. Make sure the fence is locked down before operation.
ADJUSTING THE FENCE POINTER
The fence pointer can be adjusted if it does not indicate zero. Set the
side face of the fence against the blade, and ensure the pointer is
aligned with the "0" mark on the fence scale. If it is not, loosen the two
Phillips-head mounting screws (Fig. 26 - 2), adjust the pointer, and
tighten the screws.
OPERATION
Fig. 25
1
2
Fig. 26
Fig. 27
1
2
20