![background image](http://html1.mh-extra.com/html/wen/61722/61722_instruction-manual_956335011.webp)
11
OPERATION
DRIVING MODES
Your nailer has two driving modes: single-sequential and full-sequential. For details, see below. Your tool cannot
bump-fire – that is, it cannot have the trigger pulled before the safety bracket is activated. It will not fire.
Single-sequential:
1. Press the safety bracket against the workpiece.
2. Pull the trigger. A fastener is fired.
3. Remove the safety bracket from the workpiece. Re-position the tool. Repeat steps 1 – 3.
Full-sequential:
1. Press the safety bracket against the workpiece.
2. Pull the trigger. A fastener is fired.
3. Re-position the nailer, keeping the safety bracket against the workpiece. Pull the trigger again to fire.
CLEARING JAMMED FASTENERS
WARNING!
Disconnect air line from the tool and remove all other fasteners before removing jammed fasten-
ers, in order to avoid personal injury. Keep the tool pointed away from yourself and others.
1. Disconnect the tool from the air supply. Open the magazine and remove all other fasteners from the magazine.
2. Flip open the jam-clearing latch, and pull up to open the front plate. Remove the jammed fastener, using pliers or
another tool if necessary.
3. If the piston assembly is in the down position, insert a screwdriver or other rod into the nosepiece and push the
piston back in position.
4. Close the front plate. Push down latch cover to secure the front plate to the nosepiece. Make sure the trigger and
safety bracket move freely without sticking or binding.
5. Connect the nailer to the air supply. Load fasteners. Test-fire the nailer into a piece of scrap wood to make sure
it is operating properly.
Содержание 61722
Страница 14: ...EXPLODED VIEW PARTS LIST 14...