Wen 56310i, Руководство пользователя

Страница: 11 / 40

11
STARTING THE ENGINE
To start the generator, perform the following steps:
1. Unplug all electrical devices from the generator during starting. Otherwise it can be difficult for the engine to
start.
2. Check that the generator is properly grounded (Refer to “Ground the Generator”).
3. Check the oil and fuel levels.
4. Turn the ECO MODE switch to “OFF.”
5. Turn the 3-in-1 switch to the “CHOKE” position.
6. Pull on the recoil starter handle slowly until a slight resistance is felt, then pull quickly to start the engine.
Return cord gently into the recoil starter. Never allow the cord to snap back.
7. Once the engine has started, slowly turn the 3-in-1 switch to the “ON” position.
Allow the generator to run for several minutes before attempting to connect any electrical devices. This allows
the generator to stabilize its speed and temperature.
STARTING THE GENERATOR
ECO-MODE SWITCH (ESC)
This generator is equipped with an Eco-Mode Switch. En-
gaging the switch will automatically adjust the engine speed
to match the needs of the current electrical load. When an
electrical device comes on line, the generator engine will
automatically speed up to supply the power needed and will
slow down as the need decreases. The variable engine speed
can reduce fuel consumption and noise level. Keep this
switch engaged when the power load requirement is less than
1000W. Do not engage the Idle Control Switch when the
total load is more than 1000W. The generator engine must
run at full speed to supply the required power for anything
over 1000W.
Figure 5 - Control Panel
ECO-MODE
Switch