Wen 3962, Инструкция по эксплуатации

Страница: 19 / 28

19 18
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE CAUSE SOLUTION
Band saw will not start
(no sound whatsoever).
1. Saw not plugged in.
1. Plug in saw. Did I really have to tell you to
do this?
2. Power switch turned OFF, or
safety key not inserted.
2. Insert safety key and turn saw ON.
3. Improper size/length of
extension cord.
3. Use proper extension cord. Refer to chart
on page 8.
4. Bad outlet.
4. Try another outlet, tell the outlet to be
good, or have a qualified electrician check/
replace outlet.
5. Defective power switch.
5. Stop using the tool and call 1-800-232-
1195 for customer service.
Band saw will not start
(humming sound).
1. Blade overtightened.
1. Adjust blade tension properly. See page
14.
2. Belt overtightened.
2. Adjust belt tension properly. See page
16.
3. Bad start capacitor.
3. Stop using the tool and call 1-800-232-
1195 for customer service.
4. Bad motor bearing, or bad
motor.
4. Stop using the tool and call 1-800-232-
1195 for customer service.
LED light does not
turn on.
1. Band saw is not plugged in. 1. Plug in saw.
2. LED power switch turned OFF. 2. Turn switch to ON (I).
3. Loose connection.
4. Stop using the tool and call 1-800-232-
1195 for customer service.
5. Bad LED module, or PCB.
4. Stop using the tool and call 1-800-232-
1195 for customer service.
Blade will not track
properly.
1. Blade is improperly
tensioned.
1. Adjust blade tension properly. See page
14.
2. Tracking knob is over-
adjusted.
2. Adjust tracking properly. See page 13.
3. Blade is warped. 3. Replace the blade.
4. Tires are worn.
4. Stop using the tool and call 1-800-232-
1195 for customer service.
Troubleshooting guide continues on the next page.
WARNING! Stop using the tool immediately if any of the following problems occur. Repairs and replacements
should only be performed by an authorized technician. For any questions, please contact our customer service
at (800) 232-1195, M-F 8-5 CST or email us at techsupport@wenproducts.com.