Wen 3962, Инструкция по эксплуатации

Страница: 16 / 28

17 16
ASSEMBLY & ADJUSTMENTS
ADJUSTING THE CUTTING SPEED (FIG. 19)
Your band saw can cut at 1520 or 2620 FPM. The higher
setting is generally appropriate for soft woods; the lower
setting is generally appropriate for hard woods. Make test
cuts on scrap pieces before beginning, in order to deter-
mine what setting will work best for your particular cut.
1. Turn off and unplug the band saw. Wait for the blade to
come to a complete stop. Open the lower door.
Low Speed High Speed
Lower
Wheel
Motor
Pulley
Fig. 20
Fig. 19
CAUTION! Saw blades are sharp. Always wear ANSI
Z87.1-approved eye protection, as well as protective
gloves, while handling saw blades.
2. Loosen the socket-head cap screw (A) on the back of the
motor-mounting flange, then move the motor towards the
center of the saw. This will relieve tension on the drive belt.
Tighten the screw.
3. Adjust the position of the belt. Refer to the diagram in
Fig. 20.
4. Loosen the socket-head cap screw (A) on the back of the
motor-mounting flange, and return the motor to its original
position. The weight of the motor will apply tension to the
drive belt. Press on the inside of the belt with a finger – if
the belt moves about ½ inch, the belt is properly tensioned.
Tighten the screw. Close the lower cover.
NOTE: Use the instructions above to adjust the belt tension, as needed, over the life of your saw. Older belts
may stretch with use.
USING THE POWER SWITCH (FIG. 21)
Use the power switch (C) to turn the saw ON and OFF. Remove the yellow safety key
(B) when the saw is OFF to prevent unauthorized use. Store the safety key in a safe
place out of the reach of children.
Use the light switch (A) to turn the LED light ON and OFF. The light can be used with or
without the saw running. Position the light wherever it is most useful during cutting.
OPERATION
WARNING! Do not plug in or turn on the tool until it is fully assembled
according to the instructions. Read through and become familiarized with the
following procedures of handling and adjusting your tool. Failure to follow the
safety instructions may result in serious personal injury.
Fig. 21
A
B
C
A